
How to Set Up and Use Your Propulse Ear Irrigator
When it comes to cleaning the ear canal, there are several methods to remove excess earwax. One commonly used technique by general practitioners is ear syringing, also known as ear irrigation—a process that uses a controlled and gentle stream of water to remove excess ear wax and debris.
One of the ear irrigators available for use by qualified healthcare professionals in Australia is the Propulse® Ear Irrigator—a professional system designed to assist in the removal of excess cerumen and non-hygroscopic debris from the external auditory canal using controlled, low-pressure water irrigation. The following step-by-step guide outlines how to set up and clean the Propulse® Ear Irrigator to ensure safe and effective use in clinical settings.
What’s Included in the Propulse® Ear Irrigator Kit?
Inside the Propulse® box, you’ll find the following components:
- Main Unit
- On/Off Switch
- Footswitch - Controls water flow. Activates when pressed and stops when released. Must be connected to the main unit via jack plug.
- Mains Power Adapter
- Water Container/Reservoir – Removable for easy refilling and cleaning. A horizontal line indicates the correct water level.
- Mushroom Valve – Retains water inside the reservoir when detached.•
- Handle with Non-detachable Hose – Designed to fit the Propulse® QrX™ Single-Use Tips.
- 10 QrX™ Single-Use Tips
How to Set Up the Propulse® Ear Irrigator for the First Time
Follow these steps to correctly assemble and prepare the device:
- Connect the power adapter to a mains power outlet.
- Ensure the device is turned off before plugging in both the power and footswitch.
- Check that the mushroom valve and washer are intact on the underside of the reservoir.
- Remove the protective sticker from the inside of the reservoir.
- Fill the reservoir with clean water up to the indicated horizontal fill line.
- Press the reservoir firmly onto the main unit. You should see the mushroom valve slightly lift into place.
- Insert a new QrX™ tip into the handle. Pull back the collar, insert the tip, and release the collar to lock it in.
- Turn the unit on and run an initial clean before first use.
Watch this video for a step-by-step guide on how to set up your device.
How to Clean the Propulse® Ear Irrigator:
- With the reservoir filled, add one cleaning tablet, refit the lid, and allow it to dissolve (approx. 3 minutes).
- Run the solution through the tubing to the tip, then let it sit for 10 minutes to disinfect.
- Discard the cleaning solution and rinse the reservoir under warm water.
- Fill with approximately 100 ml of clean tap water and flush the system again.
- Remove the reservoir and dry thoroughly using a disposable paper towel.
- You are now ready to begin using your Propulse® Ear Irrigator.
Watch the video for an easy-to-follow guide on how to clean your Ear Irrigator properly.
How often should you clean your Propulse® Ear Irrigator:
The Propulse Ear Irrigator should be decontaminated daily on every day it’s in use. Make sure to clean the unit before treating your first patient to ensure optimal hygiene and performance.
Why Is Cleaning Important?
Inside the Propulse® box, you’ll find the following components. Maintaining strict cleaning protocols for ear irrigation equipment helps:
- Prevent cross-contamination between patients.
- Ensure consistent device performance.
- Comply with clinical hygiene standards.
Important Safety Warnings
- This procedure should only be performed by qualified healthcare professionals.
- This product is available for purchase by Australian Healthcare Providers only.
- The Propulse® QrX™ Tip is single-use and must be disposed of properly after each patient, following local health and safety regulations.
Ear care products that complement the the ProPulse® Ear Irrigator
A full range of essential ear care products that complement the ProPulse® Ear Irrigator are available through Stark Medical. These include:
- ProPulse® Single Use QrX™ Tips
- ProPulse® Cleaning Tablets
- ProScoop™ Ear Wax Removal Scoop
- ProTect™ Shoulder Cape
- ProPulse® HeadLamp
- ProPulse Mushroom Valves
Watch the following video for a step-by-step demonstration on how to use the Ear Irrigator, along with an overview of the care products that support the device.
Propulse® Ear Irrigator User Manual
Always refer to the user manual for full operational guidance and safety recommendations. Proper setup and cleaning not only improve patient outcomes but also extend the life of your device.
Propulse® Ear Irrigator User Manual
* This content is intended for healthcare professionals only.
Leave a comment